Reply To: why i can not define the recorder when the material is steel01

HOME FORUM User Discussions why i can not define the recorder when the material is steel01 Reply To: why i can not define the recorder when the material is steel01

#23969
yuyang
Participant

here is the main file
# second example.tcl
logFile “second example.log”
set systemTime [clock seconds]

puts “===============================================================================”
puts “OpenSees Navigator: Version 2.5.5”
puts “File sourced: C:/mat/新建文件夹/yy/yyyy/y12/second example/second example.tcl”
puts “Starting OpenSees analysis: [clock format $systemTime -format “%d-%b-%Y %H:%M:%S”]”
puts “===============================================================================”

puts “\n########################”
puts “# Analysis-Sequence 1 #”
puts “########################”

# Start timing of this analysis sequence
# ————————————–
set tStart [clock clicks -milliseconds]

# Start of model generation
# =========================

# Create ModelBuilder
# ——————-
model BasicBuilder -ndm 2 -ndf 3

# Define geometry
# —————
source NodeCoord.tcl

# Define Single Point Constraints
# ——————————-
source SPConstraint.tcl

# Define nodal masses
# ——————-
source NodeMass.tcl

# Define Multi Point Constraints
# ——————————
source MPConstraint.tcl

# Define material(s)
# ——————
source Materials.tcl

# Define section(s)
# —————–
source Sections.tcl

# Define geometric transformation(s)
# ———————————-
source GeoTran.tcl

# Define element(s)
# —————–
source Elements.tcl

# Define damping parameters
# ————————-

# Define time series
# ——————
source TimeSeries.tcl

# Start of analysis generation
# ============================

# Get Initial Stiffness
# ———————
initialize

puts “o Analysis: pushover”
# ~~~~~~~~~~~~~~~~~~~~~~~~~

# Define load pattern
# ——————-
source LoadPattern_4.tcl

# Define recorder(s)
# ——————
source Recorder_4.tcl

# Define analysis options
# ———————–
source AnalysisOptn_4.tcl

# Record initial state of model
# —————————–
record

# Analyze model
# ————-
analyze 1

# Stop timing of this analysis sequence
# ————————————-
set tStop [clock clicks -milliseconds]
puts “o Time taken: [expr ($tStop-$tStart)/1000.0] sec”

# Clean up
# ——–
wipe
set systemTime [clock seconds]
puts “\n===============================================================================”
puts “Finished OpenSees analysis: [clock format $systemTime -format “%d-%b-%Y %H:%M:%S”]”
puts “===============================================================================”
exit